![]() ![]() It also supports reading using ELM327 devices and includes custom firmware to flash to support the same K-line protocol that normally requires a USB cable. ![]() No waiting on identification or scanning all modules as this is done one time in the initial config generation. It's also very fast to start as you save your config and next time you open your app you just hit "Connect" and it immediately starts talking. Much easier than bringing out the laptop or Foxwell. ![]() I successfully used it with my USB D/K-CAN cable connected to the USB-C port of my Pixel 3 phone. It's open source and pretty fast and configurable. NET equivalent and it works inside an Android app.ĭeep ODB - It is basically an Android version of INPA / ITSA-D. This stuff came about around 2016 so it is not new, but I've only recently discovered it.įolks have taken the EDIABAS interface and written a. Searching this forum doesn't yield any matches and I do not recall any discussion on this in the past. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |